Status Responses And Auto-Transmit Commands (T = 3) - Intermec 4630 User Manual

4630 and 4830 Bar Code Label Printers User's Manual
Status Responses and Auto-Transmit
Commands (t = 3)
The following responses and codes are listed in the order they must be
downloaded.
Status Description
Buffer Already Full
Printhead Test Fail
Label Path Open
Ribbon Fault
No Label Stock
Buffer Now Full
Takeup Reel Full
Label at Strip Pin, Cutter
Busy/Jammed
Skipping
Printing
Ready
Clear
Label at Strip Pin, Cutter
Busy/Jammed
Takeup Reel Full
No Label Stock
Ribbon Fault
Room in Buffer
Imager Overrun
Print Job Complete and Buffer Empty
Insufficient RAM
Note: The status responses in the above table are for standard protocol. In XON/XOFF
protocol, most of the status responses are the same; however, instead of DC1, the status
response is DC2, and instead of DC3, the status response is DC4.
6-70
Status Response
GS
SO
US
US
EM
DC3
BS
FS
DC1
DC1
DC1
DC1 -Auto-Transmit 1
FS - Auto-Transmit 1
BS - Auto-Transmit 1
EM - Auto-Transmit 1
US - Auto-Transmit 1
DC1 - Auto-Transmit 2
HT - Auto-Transmit 3
SOH - Auto-Transmit 3
RS - Auto-Transmit 3
Hex Value
1D
0E
1F
1F
19
13
08
1C
11
11
11
11
1C
08
19
1F
11
09
01
1E