Printing Configuration Test Labels - Intermec 4630 User Manual

4630 and 4830 Bar Code Label Printers User's Manual
8. Press Select and then press ↑ or ↓ until the display shows:
9. Press Enter to enable the Low Media Warn command and then press Cont

Printing Configuration Test Labels

To review the current configuration of the printer, you can print a
Configuration Test Label that shows either the user-defined software or
hardware configuration of your printer.
User-Defined This label lists the current configuration parameters that are set
from the Configuration, Operator, and Install menus, as well as defined pages,
formats, graphics, and fonts. Any printer options that you have installed are
also listed on this label.
Hardware This label lists the amount of memory installed in your printer
(static and dynamic RAM), the width and dot size of the printhead, and the
printhead mileage. The printhead mileage consists of both the amount of media
that has been processed (passed underneath the printhead) and the amount of
media that has been burned (printed).
To print a Configuration Test Label
1. From the OFFLINE READY display, press Menu and then press ↑ or ↓
2. Press Select and then press ↑ or ↓ until the display shows:
3. Press Select and then press ↑ or ↓ to reach the label you want: User-Defined
4. Press Select and then press Enter to print a Configuration Test Label.
2-26
SET WARNING
ENABLED
to return to the OFFLINE READY display.
until you reach the Service menu.
SERVICE MENU
PRINT CONFIG
or Hardware.