Chapter 2 — Configuring the PW50
Configuring the PW50
Understanding the Printer Modes
14
You can change the configuration settings of the PW50 printer by
sending commands from your PC or remotely from the SmartSystems
console.
The PW50 has seven modes to help you effectively interact with the
printer: Ready, Paused, Error, Test, and Upgrade. Use the following
sections to understand the different printer modes
Understanding Ready Mode
The printer is in Ready mode when the printer is on and ready to
print.
Understanding Pause Mode
Use Pause mode to momentarily stop printing or to cancel a current
print job. Use the Feed button to both pause and resume printing.
To enter Pause mode
•
Press the Feed button while the printer is printing.
To resume printing
•
Press the Feed button while the printer is paused.
To cancel a print job
1 Press the Feed button to pause printing.
2 Press the Feed button again to cancel the print job.
Understanding Error Mode
The printer enters Error mode when it detects an error condition such
as a low battery or a paper fault.
Understanding Test Mode
Use Test mode to verify printer settings, print test labels, restore
factory default settings, or enter Dump mode for troubleshooting
purposes. Two test modes are available: Test mode and Extended Test
mode.
PW50 Workboard Printer User's Guide