Test And Service Mode Command Descriptions - Intermec 4630 User Manual

4630 and 4830 Bar Code Label Printers User's Manual

Test and Service Mode Command Descriptions

To enter Test and Service mode from Print mode, send <ESC>T from the host
terminal.
Note: All commands in Test and Service mode end with a semicolon (;) except the last
command in a message.
Syntax Command Name
Pitch Label, Print
C;
Printer Configuration, Reset
D;
Transmissive Sensor Value,
G;
Transmit
Label Path Open Sensor Value,
L;
Transmit
M; Reflective Sensor Value, Transmit
Printhead Temperature Sensor
P;
Value, Transmit
Quality Label, Print
Q;
Test and Service mode, Exit
R;
Label Taken Sensor Value,
T;
Transmit
6-66
Description
Prints the pitch label.
Sets the printer configuration to the factory defaults.
When you exit Test and Service mode after sending this
command, the printer performs a warm boot (it resets).
Transmits the label gap transmissive sensor A/D
output back to the host. Value ranges from 00 to 255.
Transmits the paper path open switch value back to the
host. A value of 0 indicates the paper path is open and
a value of 1 means it is closed.
Transmits the label mark reflective sensor A/D output
back to the host. The value ranges from 00 to 255.
Transmits the printhead thermistor A/D output back
to the host. Range of the value is 00 to 255.
Prints the print quality program and model number
label.
Exits Test and Service mode.
Transmits the label taken sensor A/D output back to
the host. The value can range from 00 to 255.