Enabling the Cutter
1. From the OFFLINE READY display, press Menu and then press ↑ or ↓
until you reach the Configuration menu.
2. Press Select and then press ↑ or ↓ until the display shows:
CONFIGURATION
BASIC
3. Press Select and then press ↑ or ↓ until the display shows:
CONFIGURATION
CUTTER
4. Press Select and then press ↑ or ↓ until the display shows:
CUTTER
ENABLED
5. Press Enter to activate the cutter and then press Cont to return to the
OFFLINE READY display.
Testing Cutter Operation
1. From the OFFLINE READY display, press Menu and then press ↑ or ↓
until you reach the Service menu.
2. Press Select and then press ↑ or ↓ until the display shows:
SERVICE MENU
PRINT TEST LABEL
3. Press Select and then press ↑ or ↓ until the display shows:
SERVICE MENU
PRINT QUALITY
4. Press Select. The display shows:
PRINT QUALITY
EXECUTE TEST
5. Press Enter to print the quality test label.
The cutter cuts the label. After the label is cut, the printer retracts the media for
printing the next label.
Note: You may need to adjust the Label Rest Point setting on the Operator Menu if
you notice that the new label is not printing in the correct location after the previous
label has been cut. The range for the label rest point is from -30 to +30 in 5 mil
increments.
Operating and Configuring the Printer
2
2-21