Understanding Error Messages - Intermec PM4i User Manual

Understanding Error Messages

Fingerprint Error Messages
Message Description
Out of paper The printer is out of paper. Load a new roll of media.
For help, see
Next label not Next label not found
found
Label not Label not taken
taken
Out of The printer is out of transfer ribbon. Load a new roll
transfer of ribbon. For helps, see
ribbon page
Transfer This is not an error condition. This message briefly
ribbon is appears after a new roll of transfer ribbon is
installed installed.
Head lifted The printhead is lifted. Lower the printhead.
Cutter does Open and shut the cutter.
not respond
Cutter error1 Open and shut the cutter.
Cutter error2 Open and shut the cutter.
Cutter error3 Open and shut the cutter.
Cutter open Shut the cutter.
LSS too high This error can occur when you run a test feed
without any media installed, or if you have incorrect
media settings. Load the printer with media and
select the appropriate media type. For help, see
"Loading Media" on page
PM4i Mid-Range Printer User's Manual
Chapter 4 — Troubleshooting and Maintaining the Printer
Use the following tables to troubleshoot common error messages you
may see displayed on your printer's screen. Keep in mind that some
error messages:
• are specific to the type of firmware you are running.
• have corresponding error numbers.
cause the Intermec Ready-to-Work indicator to blink or turn off.
•
"Loading Media" on page
"Loading Ribbon" on
31.
9.
9.
Ready-to-Work Error
Indicator Status Number
Blinking 1005
Blinking 1031
Blinking
Blinking 1027
Blinking 1058
Blinking 1022
Blinking 1059
Blinking 1701
Blinking 1702
Blinking 1703
1704
Blinking 1007
87