Table 5-29: Network Settings -- Ip Settings Parameters - AudioCodes MP-124 User Manual

SIP User's Manual
Parameter
IP Networking Mode
[EnableMultipleIPs]
IP Address
Subnet Mask
Default Gateway Address
OAM Network Settings (available only in Multiple IPs and Dual IP modes)
IP Address
[LocalOAMIPAddress]
Subnet Mask
[LocalOAMSubnetMask]
Default Gateway Address
[LocalOAMDefaultGW]
Version 5.2
http://ArtTel.ru
Configure the IP Settings according to the table below.
2.
Click the Submit button to save your changes.
3.
To save the changes to flash memory, refer to 'Saving Configuration' on page 238.
4.

Table 5-29: Network Settings -- IP Settings Parameters

Enables / disables the Multiple IPs mechanism.
[0] Single IP Network = Single IP network (default).
[1] Multiple IP Network = Multiple IP networks.
[1] Dual IP (Media & Control) = Multiple IP networks.
[1] Dual IP (OAM & Control) = Multiple IP networks.
[1] Dual IP (OAM & Medial) = Multiple IP networks.
For detailed information on Multiple IPs, refer to 'Multiple IPs' on page
372.
IP address of the gateway.
Enter the IP address in dotted format notation, for example 10.8.201.1.
Notes:
A warning message is displayed (after clicking the button Submit) if
the entered value is incorrect.
After changing the IP address you must reset the gateway.
Subnet mask of the gateway.
Enter the subnet mask in dotted format notation, for example
255.255.0.0
Notes:
A warning message is displayed (after clicking the button Submit) if
the entered value is incorrect.
After changing the subnet mask, the gateway must be reset.
IP address of the default gateway used by the gateway.
Enter the IP address in dotted format notation, for example 10.8.0.1.
Notes:
A warning message is displayed (after clicking the button Submit) if
the entered value is incorrect.
After changing the default gateway IP address, the gateway must be
reset.
For detailed information on multiple routers support, refer to 'Multiple
Routers Support' on page 371.
The gateway's source IP address in the OAM network.
The default value is 0.0.0.0.
The gateway's subnet mask in the OAM network.
The default subnet mask is 0.0.0.0.
N/A. Use the IP Routing table instead (refer to 'Configuring the IP
Routing Table' on page 172).
Description
165
5. Web-based Management
September 2007