AudioCodes MP-124 User Manual page 178

Parameter
Echo Canceller
[EnableEchoCanceller]
DTMF Transport Type
[DTMFTransportType]
MF Transport Type
[MFTransportType]
DTMF Volume (-31 to 0 dB)
[DTMFVolume]
Enable Answer Detector
[EnableAnswerDetector]
Answer Detector Activity
Delay
[AnswerDetectorActivityDel
ay]
Answer Detector Silence Time
[AnswerDetectorSilenceTim
e]
Answer Detector Redirection
[AnswerDetectorRedirection
]
Answer Detector Sensitivity
[AnswerDetectorSensitivity]
DTMF Generation Twist
[DTMFGenerationTwist]
SIP User's Manual
http://ArtTel.ru
Table 5-34: Media Settings, Voice Settings Parameters
EnableSilenceCompression = 2 and IsCiscoSCEMode = 1
'annexb=no'.
[0] Off = Echo Canceler disabled.
[1] On = Echo Canceler enabled (default).
Note: The parameter ECE is used to maintain backward compatibility.
[0] DTMF Mute = Erase digits from voice stream, do not relay to
remote.
[2] Transparent DTMF = Digits remain in voice stream.
[3] RFC 2833 Relay DTMF = Erase digits from voice stream, relay
to remote according to RFC 2833 (default).
[7] RFC 2833 Relay Rcv Mute = DTMFs are sent according to
RFC 2833 and muted when received.
Note: This parameter is automatically updated if one of the following
parameters is configured: TxDTMFOption or RxDTMFOption.
N/A.
DTMF gain control value in dB (to the analog side).
The valid range is -31 to 0 dB.The default value is -11 dB.
N/A.
N/A.
N/A.
N/A.
Determines the Answer Detector sensitivity.
The range is 0 (most sensitive) to 2 (least sensitive). The default is 0.
Defines a delta (in dB) between the high and low frequency
components in the DTMF signal. Positive decibel values cause the
higher frequency component to be stronger than the lower one.
Negative values cause the opposite effect. For any parameter value,
both components change so that their average is constant.
The range is -10 to 10. The default value is 0.
Description
178
MediaPack Series
Document #: LTRT-65409