AudioCodes MP-124 User Manual page 91

SIP User's Manual
Parameter
Number of RTX Before
Hot-Swap
[HotSwapRtx]
User Name
[UserName]
Password
[Password]
Cnonce
[Cnonce]
Authentication Mode
[AuthenticationMode]
Set Out-Of-Service On
Registration Failure
[OOSOnRegistrationF
ail]
Version 5.2
http://ArtTel.ru
Table 5-9: Proxy & Registration Parameters
Number of retransmitted INVITE/REGISTER messages before call is routed
(hot swap) to another Proxy/Registrar.
The valid range is 1 to 30. The default value is 3.
Note: This parameter is also used for alternative routing using the Tel to IP
Routing table. If a domain name in the routing table is resolved into two IP
addresses, and if there is no response for HotSwapRtx retransmissions to
the INVITE message that is sent to the first IP address, the gateway
immediately initiates a call to the second IP address.
This parameter is used for Registration and for Basic/Digest authentication
process with a Proxy / Registrar.
The parameter doesn't have a default value (empty string).
Notes:
Applicable only if single gateway registration is used (Authentication
•
Mode = Authentication Per gateway).
The Authentication table can be used instead.
•
The password used for Basic/Digest authentication process with a Proxy /
Registrar. Single password is used for all gateway ports.
The default is 'Default_Passwd'.
Note: The Authentication table can be used instead.
String used by the SIP server and client to provide mutual authentication.
(Free format i.e., 'Cnonce = 0a4f113b'). The default is 'Default_Cnonce'.
[0] Per Endpoint = Registration and Authentication separately for each
endpoint.
[1] Per Gateway = Single Registration and Authentication for the entire
gateway (default).
[3] Per FXS Only = Registration and Authentication only for FXS
endpoints.
Usually Authentication on a per endpoint basis is used for FXS modules, in
which each endpoint registers (and authenticates) separately with its own
username and password.
Single Registration and Authentication (Authentication Mode = 1) is usually
defined for FXO ports.
Enables or disables setting an endpoint or the entire gateway (i.e., all
endpoints) to out-of-service if registration fails.
Valid options include:
[0] Disable = Disabled (default).
[1] Enable = Enabled
If the registration is per endpoint (AuthenticationMode = 0) and a specific
endpoint registration fails (4xx or no response), then that endpoint is set to
out-of-service until a success response is received in a subsequent
registration request. When the registration is per the entire gateway
(AuthenticationMode = 1), and registration fails, all endpoints are set to out-
of-service.
The out-of-service method is set according to FXSOOSBehavior.
91
5. Web-based Management
Description
September 2007