Connecting Mp-11X To Power; Installing The Mp-124 - AudioCodes MP-124 User Manual

3.1.4.5
3.2
SIP User's Manual
http://ArtTel.ru
To cable the combined MP-11x FXS/FXO Lifeline, take these 2
steps:
Connect a fax machine, modem, or phone to each of the FXS ports.
1.
Connect an analog PSTN line to each of the FXO ports.
2.
The use of the Lifeline on network failure can be disabled using the
Note:
LifeLineType ini file parameter (described in 'System Parameters' on page
264).

Connecting MP-11x to Power

The MP-11x is powered from a standard AC electrical outlet.
Units must be connected (by service personnel) to a socket-outlet with a
Warning:
protective earthing connection.
To connect MP-11x to the power supply:
Connect the MP-11x power socket to a standard electrical outlet using the supplied
AC power cord.

Installing the MP-124

To install the MP-124, perform the following installation steps in chronological order:
Unpack the MP-124 (refer to 'Unpacking' on page 37).
Check the package contents (refer to 'Package Contents' on page 37).
Mount the MP-124 (refer to 'Mounting the MP-124' on page 37).
Cable the MP-124 (refer to 'Cabling the MP-124' on page 40).
After connecting the MP-124 to the power source, the Ready and LAN LEDs on the front
panel light up green (after a self-testing period of about 1 minute). Any malfunction
changes the Ready LED to red.
When you have completed the above installation steps, you are then ready to start
configuring the gateway (refer to 'Web-based Management' on page 55).
36
MediaPack Series
Document #: LTRT-65409