AudioCodes MP-124 User Manual page 104

Parameter
Broken Connection
Timeout
[BrokenConnectionEvent
Timeout]
Disconnect Call on Silence
Detection
[EnableSilenceDisconnec
t]
Silence Detection Period
[sec]
[FarEndDisconnectSilenc
ePeriod]
Silence Detection Method
[FarEndDisconnectSilenc
eMethod]
Enable Fax Re-Routing
[EnableFaxReRouting]
Send Digit Pattern on
Connect
[TelConnectCode]
SIP User's Manual
http://ArtTel.ru
Table 5-12: General Parameters (Advanced Parameters)
The amount of time (in 100 msec units) an RTP packet isn't received,
after which a call is disconnected.
The valid range is 1 to 1000. The default value is 100 (i.e., 10 seconds).
Notes:
Applicable only if DisconnectOnBrokenConnection = 1.
Currently, this feature works only if Silence Suppression is disabled.
[1] Yes = The gateway disconnect calls in which silence occurs in
both (call) directions for more than 120 seconds.
[0] No = Call is not disconnected when silence is detected (default).
The silence duration can be set by the FarEndDisconnectSilencePeriod
parameter (default 120).
Note: To activate this feature set EnableSilenceCompression to 1 and
FarEndDisconnectSilenceMethod to 1.
Duration of silence period (in seconds) prior to call disconnection.
The range is 10 to 28,800 (i.e., 8 hours). The default is 120 seconds.
Silence detection method.
[0] None = Silence detection option is disabled.
[1] Packets Count = According to packet count.
[2] Voice/Energy Detectors = N/AAccording to energy and voice
detectors (default).
[3] All = N/AAccording to packet count, and energy and voice
detectors.
Enables or disables re-routing of Tel-to-IP calls that are identified as fax
calls.
Valid options include:
[0] Disable = Disabled (default).
[1] Enable = Enabled.
If a CNG tone is detected on the Tel side of a Tel-to-IP call, a "FAX"
prefix is appended to the destination number before routing and
manipulations occur. Standard Tel-to-IP routing table mechanism is then
used to route the call, and the destination number manipulation
mechanism is used to remove the "FAX" prefix, if required.
If the initial INVITE that is used to establish the voice call (not Fax) was
already sent, a CANCEL (if not connected yet) or a BYE (if already
connected) is sent to tear down the voice call.
Defines a digit pattern that is sent to the Tel side after 200 OK is
received from the IP side. The digit pattern is a predefined DTMF
sequence that is used to indicate an answer signal (e.g., for billing
purposes). Applicable only to FXS gateways.
The valid range is 1 to 8 characters.
Description
104
MediaPack Series
Document #: LTRT-65409