RTP Multiplexing Local UDP Port
[L1L1ComplexTxUDPPort]
RTP Multiplexing Remote UDP
Port
[L1L1ComplexRxUDPPort]
5.7.4
SIP User's Manual
http://ArtTel.ru
Table 5-36: Media Settings, RTP / RTCP Parameters
Parameter
Determines the local UDP port used for outgoing multiplexed RTP
packets (applies to the ThroughPacket™ mechanism).
The valid range is the range of possible UDP ports: 6,000 to
64,000.
The default value is 0 (ThroughPacket is disabled).
This parameter cannot be changed on-the-fly and requires a
gateway reset.
Determines the remote UDP port the multiplexed RTP packets are
sent to, and the local UDP port used for incoming multiplexed RTP
packets (applies to the ThroughPacket™ mechanism).
The valid range is the range of possible UDP ports: 6,000 to
64,000.
The default value is 0 (ThroughPacket is disabled).
This parameter cannot be changed on-the-fly and requires a
gateway reset.
Note: All gateways that participate in the same ThroughPacket
session must use the same L1L1ComplexRxUDPPort.
Configuring the Hook-Flash Settings
The 'Hook-Flash Settings' screen is used for configuring Hook-Flash parameters.
To configure the Hook-Flash Settings parameters, take these 4
steps:
Open the 'Hook-Flash Settings' screen (Advanced Configuration menu > Media
1.
Settings > Hook-Flash Settings option).
Figure 5-45: Hook-Flash Settings Screen
Configure the Hook-Flash Settings according to the table below.
2.
Click the Submit button to save your changes.
3.
To save the changes to flash memory, refer to 'Saving Configuration' on page 238.
4.
Description
186
MediaPack Series
Document #: LTRT-65409