Integrating Using The Embedded Web Server; Figure 8-2: Vlan Settings Screen - Example - AudioCodes MP-124 User Manual

8.9.3.1
SIP User's Manual
http://ArtTel.ru

Integrating Using the Embedded Web Server

The procedure below describes how to integrate the gateway into a VLAN and multiple IPs
network using the Embedded Web Server.
To integrate the gateway into a VLAN and multiple IPs network
using the Embedded Web Server, take these 7 steps:
Access the Embedded Web Server (refer to 'Accessing the Embedded Web Server'
1.
on page 58).
Use the Software Upgrade Wizard ('Software Upgrade Wizard' on page 226) to load
2.
and burn the firmware version to the gateway (VLANs and multiple IPs support is
available only when the firmware is burned to flash).
Configure the VLAN parameters by completing the following steps:
3.
Open the 'VLAN Settings' screen (Advanced Configuration menu > Network
a.
Settings > VLAN Settings option).
Modify the VLAN parameters to correspond to the values shown in the following
b.
figure.

Figure 8-2: VLAN Settings Screen - Example

Click the Submit button to save your changes.
c.
Configure the multiple IP parameters by completing the following steps:
4.
Open the 'IP Settings' screen (Advanced Configuration menu > Network
a.
Settings > IP Settings option).
Modify the IP parameters to correspond to the values shown in the figure below.
b.
Note that the OAM, Control, and Media Network Settings parameters appear only
after you select the options 'Multiple IP Networks' or 'Dual IP' in the field 'IP
Networking Mode'.
Configure the OAM parameters only if the OAM networking parameters are
Note:
different from the networking parameters used in the Single IP Network mode.
376
MediaPack Series
Document #: LTRT-65409