Dynamic Jitter Buffer Minimum
Delay
[DJBufMinDelay]
Dynamic Jitter Buffer
Optimization Factor
[DJBufOptFactor]
RTP Redundancy Depth
[RTPRedundancyDepth]
Packing Factor
[RTPPackingFactor]
Basic RTP Packet Interval
[BasicRTPPacketInterval]
RTP Directional Control
[RTPDirectionControl]
RFC 2833 TX Payload Type
[RFC2833TxPayloadType]
RFC 2833 RX Payload Type
[RFC2833RxPayloadType]
RFC 2198 Payload Type
[RFC2198PayloadType]
Fax Bypass Payload Type
[FaxBypassPayloadType]
Enable RFC 3389 CN Payload
Type
[EnableStandardSIDPayloadTy
pe]
SIP User's Manual
http://ArtTel.ru
Table 5-36: Media Settings, RTP / RTCP Parameters
Parameter
Minimum delay for the Dynamic Jitter Buffer.
The valid range is 0 to 150 milliseconds. The default delay is 10
milliseconds.
Note: For more information on the Jitter Buffer, refer to 'Dynamic
Jitter Buffer Operation' on page 341.
Dynamic Jitter Buffer frame error / delay optimization factor.
The valid range is 0 to 13. The default factor is 10.
Notes:
N/A. Controlled internally by the gateway according to the selected
coder.
N/A. Controlled internally by the gateway according to the selected
coder.
Note: This parameter should not be used. Use the 'Coders' screen
under 'Protocol Definition' instead.
N/A. Controlled internally by the gateway according to the selected
coder.
N/A. Use the ini file parameter RFC2833PayloadType instead.
N/A. Use the ini file parameter RFC2833PayloadType instead.
RTP redundancy packet payload type, according to RFC 2198.
The range is 96-127. The default is 104.
Applicable if RTP Redundancy Depth = 1.
Determines the fax bypass RTP dynamic payload type.
The valid range is 96 to 120. The default value is 102.
Determines whether Silence Indicator (SID) packets that are sent
and received are according to RFC 3389.
Description
Set to 13 for data (fax and modem) calls.
For more information on the Jitter Buffer, refer to 'Dynamic
Jitter Buffer Operation' on page 341.
[0] 0 = Disable the generation of redundant packets (default).
[1] 1 = Enable the generation of RFC 2198 redundancy
packets.
[0] Disable = G.711 SID packets are sent in a proprietary
method (default).
[1] Enable = SID (comfort noise) packets are sent with the RTP
SID payload type according to RFC 3389. Applicable to G.711
and G.726 coders.
184
MediaPack Series
Document #: LTRT-65409