AudioCodes MP-124 User Manual page 112

Sip cpe & access analog gateways
Hide thumbs Also See for MP-124:
Table of Contents

Advertisement

Parameter
Caller ID Type
[CallerIDType]
Hook-Flash Code
[HookFlashCode]
MWI Parameters
Enable MWI
[EnableMWI]
MWI Analog Lamp
[MWIAnalogLamp]
SIP User's Manual
http://ArtTel.ru
Table 5-13: Supplementary Services Parameters
Defines one of the following standards for detection (FXO) and generation
(FXS) of Caller ID, and detection (FXO) generation (FXS) of MWI (when
specified) signals:
[0] Bellcore = Caller ID and MWI (default)
[1] ETSI = Caller ID and MWI
[2] NTT
[4] Britain
[16] DTMF ETSI
[17] Denmark = Caller ID and MWI
[18] India
[19] Brazil
Notes:
Typically, the Caller ID signals are generated/detected between the first
and second rings. However, sometimes the Caller ID is detected before
the first ring signal (in such a scenario, configure RingsBeforeCallerID
to 0).
Caller ID detection for Britain [4] is not supported on the gateway's FXO
ports. Only FXS ports can generate the Britain [4] Caller ID.
To select the Bellcore Caller ID sub standard, use the parameter
BellcoreCallerIDTypeOneSubStandard. To select the ETSI Caller ID
substandard, use the parameter ETSICallerIDTypeOneSubStandard.
To select the Bellcore MWI sub standard, use the parameter
BellcoreVMWITypeOneStandard. To select the ETSI MWI sub
standard, use the parameter ETSIVMWITypeOneStandard.
Determines a digit pattern which, when received from the Tel side,
indicates a Hook Flash event. The valid range is a 25-character string.
Enable MWI (Message Waiting Indication).
[0] Disable = Disabled (default).
[1] Enable = MWI service is enabled.
Notes:
This parameter is applicable only to FXS modules.
The gateway supports only the reception of SIP MWI NOTIFY
messages (the gateway doesn't generate these messages).
For detailed information on MWI, refer to Message Waiting Indication
on page 360.
[0] Disable = Disable (default).
[1] Enable = Enables visual Message Waiting Indication. Supplies line
voltage of approximately 100 VDC to activate the phone's lamp.
Note: This parameter is applicable only to FXS modules.
112
Description
Document #: LTRT-65409
MediaPack Series

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents