AudioCodes MP-124 User Manual page 74

Parameter
SIP TCP Local Port
[TCPLocalSIPPort]
SIP TLS Local Port
[TLSLocalSIPPort]
Enable SIPS
[EnableSIPS]
Enable TCP Connection
Reuse
[EnableTCPConnection
Reuse]
TCP Timeout
[SIPTCPTimeout]
SIP Destination Port
[SIPDestinationPort]
Use "user=phone" in SIP
URL
[IsUserPhone]
Use "user=phone" in
From Header
[IsUserPhoneInFrom]
Use Tel URI for Asserted
Identity
[UseTelURIForAsserted
ID]
Tel to IP No Answer
Timeout
[IPAlertTimeout]
SIP User's Manual
http://ArtTel.ru
Table 5-8: General Parameters (Protocol Definition)
Local TCP port used to receive SIP messages.
The default value is 5060.
Local TLS port used to receive SIP messages.
The default value is 5061.
Note: The value of TLSLocalSIPPort must be different to the value of
TCPLocalSIPPort.
Enables secured SIP (SIPS) connections over multiple hops.
[0] Disable (default).
[1] Enable.
When SIPTransportType = 2 (TLS) and EnableSIPS is disabled, TLS is
used for the next network hop only. When SIPTransportType = 2 (TLS) or
1 (TCP) and EnableSIPS is enabled, TLS is used through the entire
connection (over multiple hops).
Note: If SIPS is enabled and SIPTransportType = UDP, the connection
fails.
Enables the reuse of the same TCP connection for all calls to the same
destination.
Valid options include:
[0] Disable = Use a separate TCP connection for each call (default)
[1] Enable = Use the same TCP connection for all calls
Defines the Timer B and Timer F (as defined in RFC 3261) when the SIP
Transport Type is TCP.
The valid range is 0 to 40 sec. The default value is SIPT1Rtx * 64 msec.
SIP destination port for sending initial SIP requests.
The valid range is 1 to 65534. The default port is 5060.
Note: SIP responses are sent to the port specified in the Via header.
[0] No = 'user=phone' string isn't used in SIP URI.
[1] Yes = 'user=phone' string is part of the SIP URI (default).
[0] No = Doesn't use ';user=phone' string in From header (default).
[1] Yes = ';user=phone' string is part of the From header.
Determines the format of the URI in the P-Asserted and P-Preferred
headers.
[0] Disable = 'sip:' (default).
[1] Enable = 'tel:'.
Defines the time (in seconds) the gateway waits for a 200 OK response
from the called party (IP side) after sending an INVITE message. If the
timer expires, the call is released.
The valid range is 0 to 3600. The default value is 180.
Description
74
MediaPack Series
Document #: LTRT-65409