AudioCodes MP-124 User Manual page 80

Parameter
Subject
[SIPSubject]
Multiple Packetization
Time Format
[MultiPtimeFormat]
Enable Reason Header
[EnableReasonHeader]
Enable Semi-Attended
Transfer
[EnableSemiAttendedTr
ansfer]
3xx Behavior
[3xxBehavior]
Enable P-Charging
Vector
[EnablePChargingVecto
r]
Enable VoiceMail URI
[EnableVMURI]
SIP User's Manual
http://ArtTel.ru
Table 5-8: General Parameters (Protocol Definition)
Defines the value of the Subject header in outgoing INVITE messages. If
not specified, the Subject header isn't included (default).
The maximum length of the subject is limited to 50 characters.
Determines whether the 'mptime' attribute is included in the outgoing SDP.
Valid options include:
[0] None = Disabled (default)
[1] PacketCable = includes the mptime attribute in the outgoing SDP --
PacketCable-defined format
The 'mptime' attribute enables the gateway to define a separate
Packetization period for each negotiated coder in the SDP. The 'mptime'
attribute is only included if this parameter is enabled, even if the remote
side includes it in the SDP offer.Upon reception, each coder receives its
'ptime' value in the following precedence:
From 'mptime' attribute.
From 'ptime' attribute.
Default value.
Enables / disables the usage of the SIP Reason header.
[0] Disable.
[1] Enable (default).
Determines the gateway behavior when Transfer is initiated while still in
Alerting state.
Valid options include:
[0] Disable = Send REFER with Replaces (default).
[1] Enable = Send CANCEL, and after a 487 response is received,
send REFER without Replaces.
Determines the gateway's behavior when a 3xx response is received for
an outgoing INVITE request. The gateway can either use the same call
identifiers (CallID, branch, to and from tags) or change them in the new
initiated INVITE.
[0] Forward = Use different call identifiers for a redirected INVITE
message (default).
[1] Redirect = Use the same call identifiers.
Enables the addition of a P-Charging-Vector header to all outgoing INVITE
messages.
Valid options include:
[0] Disable = Disable (default)
[1] Enable = Enable
Enables or disables the interworking of target and cause for redirection
from Tel to IP and vice versa, according to RFC 4468.
Valid options include:
[0] Disable = Disable (default).
[1] Enable = Enable
Description
80
MediaPack Series
Document #: LTRT-65409