Advanced Configuration
Interfaces
Interfaces
From the Interfaces tab, you configure the Access Point's operational mode settings, power control settings, wireless
interface settings and Ethernet settings. You may also configure a Wireless Distribution System for AP-to-AP
communications. The Interfaces tab contains the following sub-tabs:
•
Operational Mode
•
Wireless (802.11a/b/g Radio)
•
Ethernet
Operational Mode
From this tab, you can configure and view the operational mode for the Wireless interface.
Figure 4-9 Operational Mode Screen
The Wireless (802.11a/b/g) interface can be configured to operate in the following modes:
•
802.11a only mode: The radio uses the 802.11a standard only.
•
802.11b mode only: The radio uses the 802.11b standard only.
•
802.11g mode only: The radio is optimized to communicate with 802.11g devices. This setting will provide the best
results if this radio interface will only communicate with 802.11g devices.
•
802.11b/g mode: This is the default mode. Use this mode if you want to support a mix of 802.11b and 802.11g
devices.
AP-700 User Guide
46