Installing The Security Cover - Proxim ORiNOCO AP-700 User Manual

Getting Started
5. Verify LED Status
6. When the AP-700 boots, it performs a series of self-tests.
7. Wait for the power LED to turn green before proceeding.

Installing the Security Cover

You can optionally install a security cover to deter unauthorized access to the AP-700. The security cover is a plastic
cover that prevents access to the cabling and to the Reset and Reload buttons.
NOTE
You cannot connect an RS-232 cable to the AP-700 when a security cover is installed.
1. Slide the hinging end of the security cover into the hole on the rear panel of the AP-700 to the left of the
connectors.
2. Use two screws to screw the right side of the security cover to the RS-232 screw holes on the rear panel of the
AP-700.
Mounting the AP-700
Conduct a site survey to determine the best location for your device. Once you have chosen a final location for your
unit, mount the AP-700 to a wall or a T-bar ceiling as follows:
Mounting the AP-700 to a Ceiling
1. Attach the mounting plate to the bottom of the AP-700 by lining up the keyholes and attaching it with two screws.
2. Snap the tabs onto the ceiling T-bar. Rotate the AP-700 until it snaps on to the T-bar.
BACK
Figure 2-3 AP-700 Mounting Plate
FRONT
21