Alarms Parameters - Proxim ORiNOCO AP-700 User Manual

Command Line Interface (CLI)
Parameter Tables
Name
Port Number
Protocol Name
Interface Bitmask
Status (optional)

Alarms Parameters

SNMP Table Host Table Parameters
When creating table entries, you may either specifying the argument name followed by argument value. CLI applies
default values to the omitted arguments. Due to the nature of the information, the only argument that can be omitted is
the "comment" argument.
Name
SNMP Trap Host Table
Table Index
IP Address
Password
Comment (optional)
Status (optional)
Syslog Parameters
The following parameters configure the Syslog settings.
Name
Syslog
Type
Octet String User Defined
(there are also 4
pre-defined protocols:
Index 1: NetBios Name
Service - 137, Index 2:
NetBios Datagram
Service - 138, Index 3:
NetBios Session Service
- 139, Index 4: SNMP
Service - 161)
DisplayString User Defined
(there are also 4
pre-defined protocols,
see
Integer32 0 or 2 = No interfaces
(disable)
1 or 3 = Ethernet
4 or 6 = Wireless
5 or 7 = All interfaces
(default is 7)
Integer enable (default for new
entries)
disable (default for
pre-defined entries)
delete
Type
Table N/A
Integer User Defined
IpAddress User Defined
DisplayString User Defined (up to 64
characters)
DisplayString User Defined (up to 254
characters)
Integer enable (default)
disable
delete
Type
Group N/A
Value Access
RW
RW
Port Number above)
RW
RW
Value Access
Value Access
R
AP-700 User Guide
CLI Parameter
portnum
protoname
ifbitmask
status
CLI Parameter
R snmptraphosttbl
N/A index
RW ipaddr
W passwd
RW cmt
RW status
CLI Parameter
syslog
192