Configuring A Non-Compatible Gige Or A Fast Ethernet Network Adapter Used With Your Cameras - Basler Pioneer User Manual

Software and Hardware Installation
2.2.5.1 Configuring a Non-compatible GigE or a Fast Ethernet Network
Adapter Used with Your Cameras
The following procedures assume that the Basler filter driver was installed on your PC during
Installation of the Basler pylon SDK, during installation of the Basler pylon Viewer, or as an
individual software component. After the installation, the settings of each Fast Ethernet or non-
compatible network adapter used with your camera must be checked and adjusted, if necessary:
1. Open a Network Connections window and find the connection for your network adapter that is
used with cameras. (Make sure that the window is set to display details (right click within the
window, select View, and select Details).
If you have multiple Fast Ethernet or non-compatible GigE adapters that are used with your
cameras, select any one of them.
2. Right click on the name of the connection and select Properties from the drop down menu as
shown below.
3. A LAN Connection Properties window will open as shown below.
4. Look at the list of items in the center of the Local Area Connection Properties window.
a. Make sure that the Pylon GigE Vision Streaming Filter and the Internet Protocol (TCP/IP)
items are checked as shown below.
b. Make sure that all of the other items in the list are unchecked. (Note that you may need to
scroll the list up or down to see all of the items.)
30 Basler pioneer