Using An Unassigned Input Line To Receive A User Input Signal - Basler Pioneer User Manual

I/O Control
12.1.2 Using an Unassigned Input Line to Receive
a User Input Signal
You can use an unassigned input line to receive your own, user-generated input signal. The
electrical characteristics of your input signal must meet the requirements shown in the Physical
Interface section of this manual.
You can use the Line Status or Line Status All parameters to monitor the state of the input line that
is receiving the user-defined signal.
Note
The line assigned to receive the ExTrig input signal can't be used to receive a
user-designed input signal.
For more information about using the Line Status and Line Status All parameters, see
Section 12.3.1 on page 175
166
and Section 12.3.2 on page 175.
Basler pioneer