Automatic Overlapping Of Image Acquisitions (All Cameras) - Basler DART BCON SERIES User Manual

Image Acquisition Control
9.5.1 Automatic Overlapping of Image Acquisitions
(All Cameras)
If the camera allows overlapped image acquisitions (see
exposures and readouts to maximize the frame rate or to achieve a specific frame rate.
If the camera does not allow overlapped image acquisitions, the camera's maximum allowed frame
rate will be limited by the duration of the frame acquisition process (exposure + readout).
To allow overlapping image acquisitions, the camera must be in the continuous
acquisition mode. Overlapping image acquisition can't be performed if the
camera's acquisition mode is set to single frame.
For more information about the acquisition mode, see Section 9.1 on
Camera Model
daA1280-54bm/bc
daA1600-60bm/bc
daA2500-14bm/bc
(*) Overlapping image acquisitions are allowed unless you manually disable them using the OverlapMode
parameter. For more information, see Section 9.5.2 on
Table 29: Conditions for Overlapping Image Acquisitions
For more information about
rolling shutter modes, see Section 9.4.2 on

trigger modes, see Section 9.2.1 on

74
Rolling Shutter Mode
Not applicable
(global shutter camera)
ERS
ERS
GRR
GRR
page 59.
Table 29), it will automatically overlap
Trigger Mode
On (software / hardware)
Off (free run)
On (software / hardware)
Off (free run)
On (software / hardware)
Off (free run)
page 75.
page 70.
AW00136902000
page 57.
Overlapping Image
Acquisitions allowed?
No
Yes (*)
Yes
Yes
No
No
Basler dart BCON