Table of Contents
Advertisement
9.5 Input Power
Input power must be supplied to the camera's 12-pin connector via the power and I/O cable.
Nominal input voltage is +12 VDC, however, the camera will operate properly on any input voltage
between +12.0 VDC and +24.0 VDC with less than one percent ripple. Power consumption is as
shown in the specification tables in Section 1 of this manual.
.
Voltage Outside of Specified Range Can Damage the Camera
If the voltage of the input power to the camera is greater than +24 VDC
damage to the camera can result. If the voltage is less than +12 VDC, the
camera may operate erratically.
CAUTION
An Incorrect Plug Can Damage the 12-pin Connector
The plug on the cable that you attach to the camera's 12-pin connector must
have 12 pins. Use of a smaller plug, such as one with 10 pins or 8 pins, can
damage the pins in the camera's 12-pin connector.
CAUTION
For more information about the 12-pin connector and the I/O cable see Section 9.2 on
and Section 9.3 on
page
9.6 Ethernet GigE Device Information
The camera uses a standard Ethernet GigE transceiver. The transceiver is fully 100/1000 Base-T
802.3 compliant.
Basler pioneer
104.
Physical Interface
page 102
107
Advertisement
Table of Contents
