Basler Pioneer User Manual page 75

3. An Internet Protocol Properties window will open as shown below.
a. On the General tab, make sure that the Obtain an IP address automatically radio button is
selected. (This sets the adapter to check for a DHCP server as its first choice.)
4. Click on the Alternate Configuration tab. The settings on this tab are used to set the alternate
configuration that the adapter will use if no DHCP server is found.
a. Select the Automatic private IP address radio button as shown below.
5. Click the OK button on the Internet Protocol Properties window.
6. Click the Close button on the LAN Connection Properties window.
Note
There is a limitation you must be aware of when set adapters to use Automatic
Private IP Addressing (APIPA) as an alternate configuration. If a PC is
equipped with multiple network adapters, APIPA can only be used on one of
the adapters. If APIPA is enabled on more than one adapter, the network will
not operate properly.
Note that if your PC is equipped with a multiport network adapter board, each
port is considered to be the equivalent of a separate adapter. APIPA should
be enabled on only one port.
Basler pioneer
Camera and Network Adapter IP Configuration
65