Ip Addressing; To Set Up And Install The Switch In Your Network; Need Only A Quick Start - HP ProCurve 2810 Series Management And Configuration Manual

Getting Started

Need Only a Quick Start?

I m po r t a n t !
1-6
Need Only a Quick Start?

IP Addressing

If you just want to give the switch an IP address so that it can communicate
on your network, or if you are not using multiple VLANs, ProCurve
recommends that you use the Switch Setup screen to quickly configure IP
addressing. To do so, do one of the following:
Enter setup at the CLI Manager level prompt.
■
ProCurve# setup
■ In the Main Menu of the Menu interface, select
8. Run Setup
For more on using the Switch Setup screen, see the Installation and Getting
Started Guide you received with the switch.

To Set Up and Install the Switch in Your Network

Use the Quick Installation Guide shipped with your switch for the following:
Notes, cautions, and warnings related to installing and using the
■
switch
■ Instructions for physically installing the switch in your network
■ Quickly assigning an IP address and subnet mask, setting a Manager
password, and (optionally) configuring other basic features.
Interpreting LED behavior.
■
For the latest version of the Installation and Getting Started Guide and other
documentation for your switch, visit the ProCurve Networking Web site.
(Refer to "Product Documentation" on page xv of this guide for further
details.)