Need Only A Quick Start; To Set Up And Install The Switch In Your Network - HP procurve switch 2650 Access Security Manual

Hide thumbs Also See for procurve switch 2650:
Table of Contents

Advertisement

Need Only a Quick Start?

IP Addressing. If you just want to give the switch an IP address so that it
can communicate on your network, or if you are not using VLANs, HP
recommends that you use the Switch Setup screen to quickly configure IP
addressing. To do so, do one of the following:
Enter setup at the CLI Manager level prompt.

HPswitch# setup
In the Main Menu of the Menu interface, select

8. Run Setup
For more on using the Switch Setup screen, see the Installation and Getting
Started Guide you received with the switch.

To Set Up and Install the Switch in Your Network

Use the HP Procurve Switch 2650 and 6108 Installation and Getting Started
Guide (shipped with the switch) for the following:
Notes, cautions, and warnings related to installing and using the switch

and its related modules
Instructioins for physically installing the switch in your network

Quickly assigning an IP address and subnet mask, set a Manager pass-

word, and (optionally) configure other basic features.
Getting Started

Need Only a Quick Start?

xvii

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve 6108

Table of Contents