N o t e
Need Only a Quick Start?
IP Addressing. If you just want to give the switch an IP address so that it
can communicate on your network, ProCurve recommends that you use the
CLI to quickly configure IP addressing and enable Telnet access to the switch:
see
"Setting the Management Module IP Address" on page 4-2
For an introduction and overview on using the CLI, refer to
the Command Line Interface
features, see
Chapter 4, "Configuring Basic System Information and Port
Parameters".
To Set Up and Install the Switch in Your Network
For instructions on how to physically install the switch and its components in
your network, refer to the Installation and Getting Started Guide that
shipped with your switch. This provides information on the following:
■
Notes, cautions, and warnings related to installing the switch and its
related modules
Instructions for mounting the switch and physically installing its
■
modules, fans, and power
■
Procedures for setting up basic system information and passwords.
Descriptions for interpreting LED behavior on the switch.
■
(CLI)". For instructions on setting up basic
Getting Started
Need Only a Quick Start?
for details.
Chapter 2, "Using
1-5