Release K.13.43; Release K.13.44 - HP ProCurve 3500yl Release Notes

CLI (PR_0000004042) —
■
does not work as expected when the destination IP address of the SNMP Request is the
Loopback IP. The source IP address of the SNMP Response should be the destination IP of
the SNMP Request, but instead the switch uses the IP address of the active interface from
which the SNMP Response was sent.
CLI (PR_0000007686) — The switch does not allow IP authorized-manager configuration
■
of 10.0.0.0.
■ TACACS+ (PR_0000003839) — The TACACS server configuration parameter accepts an
address from an invalid/reserved IP range: 0.0.0.1 to 0.255.255.255.
■ Boot Log (PR_0000009434) — The switch doesn't create an event log message after
deleting an invalid TACACS server host config entry upon bootup following an update
from K.12.xx to K.13.xx

Release K.13.43

The following problems were resolved in release K.13.43 (Not a public release).
CLI (PR_0000005759) — There may be odd CLI output in response to a show modules
■
command, if that command is executed during module initialization.
SNMP (PR_0000001926) — An SNMP query for the MIB ifInUnknownProtos returns
■
incorrect and varying results.
Enhancement (PR_0000003557) — The ability to enable/disable the USB port via CLI and
■
SNMP was added. Note that after being disabled and subsequently re-enabled, the USB port
may not function consistently with the PCM USB Autorun features until the switch has been
reloaded. For more information, see

Release K.13.44

The following problems were resolved in release K.13.44 (Not a public release).
ICMP Redirects (PR_0000004534) — With the next hop router is in the same VLAN as
■
the host machine, the switch does not generate ICMP redirects.
Crash (PR_0000009736) — In some situations, ICMP redirects may cause the switch to
■
crash with a message similar to the following.
PPC Data Storage (Bus Error) exception vector 0x300: Stack
Frame=0x084f2e40
HW Addr=0x00cff108 IP=0x00870e5c Task='mIpPktRecv' Task ID=0x84f3140
fp: 0x0a84d994
The CLI command snmp-server response-source dst-ip-of-request
"Release K.13.43 Enhancements" on page
Software Fixes in Release K.11.12 - K.13.49
143.
Release K.13.43
202