Release K.11.69; Release K.12.01 - HP ProCurve 3500yl Release Notes

Release K.11.69

The following problems were resolved in release K.11.69
Routing (PR_1000392086) — The switch learns a bogus MAC address when the next hop
■
address is unknown, causing the switch to stop forwarding traffic.
Release K.11.69 is the last release of the K.11.xx software. The 3500yl, 6200yl, and 5400zl switch
series software code was rolled to the K.12.0x code branch with no intervening releases.

Release K.12.01

The following problems were resolved in release K.12.01
ACL (PR_1000393287) — When the same ACL is applied (in or out) to more than 2 VLANs
■
it does not get applied to the third VLAN or higher.
ACL (PR_1000389442) — Numbering restrictions are not enforced at the CLI; ACLs
■
numbered 200 or higher are considered valid. This fix enforces ACL numbering restrictions
and converts existing ACLs numbered 200 or higher into named ACLs. If an invalid name of
form XXX is found, it will be converted to "invalidXXX".
Note:
If you have ACLs configured with numbers greater than or equal to 200, you need to
reconfigure those ACLs with either a valid name or valid number prior to loading K.12.01
software, or it will be tagged as invalid. For example, if you have an ACL called 222 and it is
applied to a vlan, the K.12.01 script will convert the 222 ACL to "invalid222" and apply it to
the vlan.
CLI (PR_1000332352) — The output of a show int brief command should show the
■
negotiated flow control status rather than the flow control configuration setting.
Crash (PR_1000385237) — Applying an access control list with more than 105 entries to
■
a VLAN interface causes the switch to crash with a message similar to:
Software exception at enDecode.c:54 -- in 'mSess1',
task ID = 0x8e7da60 -> out of memory!
■ Crash (PR_1000392105) — Specific actions in the port status screen of the menu interface
may trigger a crash. Scrolling down to the ports on a module in slot L and pressing [enter]
may cause the switch to crash with a message similar to:
Software exception at exception.c:424 -- in 'mSess1',
task ID = 0x8dd1ab0 -> Memory system error at 0x881a480 - memPartFree
Software Fixes in Release K.11.12 - K.13.49
Release K.11.69
160