HP ProCurve 3500yl Release Notes page 195

Enhancement (PR_ 0000000081) — The CLI clear module command allows you to remove
■
module configuration information from the configuration file. For more information, see
"Release K.13.04 Enhancements" on page
Enhancement (PR_ 0000000082) — The CLI track interface command allows you to
■
configure tracking for a port or list of ports, or a trunk or list of trunks. For more information,
see "Release K.13.04 Enhancements" on page
■ Enhancement (PR_ 0000000084) — DHCP Option 66 provides a way to automatically
download and initially boot from a configuration that is different from the factory-shipped
configuration. For more information, see
■ Enhancement (PR_ 0000000085) — The DHCP relay address configuration enhancement
provides a way to configure a gateway address for the DHCP relay agent to use for DHCP
requests, rather than the DHCP relay agent automatically assigning the lowest-numbered IP
address. For more information, see
■ Enhancement (PR_ 0000000086) — This enhancement allows rate-limiting of inbound
broadcast and multicast traffic on the switch. For more information, see
Enhancements" on page
Enhancement (PR_ 0000000087) — This enhancement enables a Telnet client to use the
■
hostname in command input. For more information, see
on page 76.
Enhancement (PR_ 0000000089) — The CLI show modules command displays additional
■
component information for system support modules and mini-GBICS. For more information,
see "Release K.13.04 Enhancements" on page
Enhancement (PR_ 0000000101) — This enhancement adds a vrrp option to the debug
■
command. For more information, see
Enhancement (PR_ 0000000420) — This enhancement provides the show tech option for
■
customizing copy tftp output. For more information, see
page 76.
'show tech' (PR_0000000635) — The show tech CLI command will cause an "Invalid
■
input: power" error message to be displayed in the ProCurve Switch 6200yl-24G-mGBIC.
CLI (PR_0000000358) — The output from the show modules CLI command shows the
■
module serial number as being all zeros, or fails to show any output at all for that value.
CLI/sFlow (PR_0000000360) — The switch administrator is unable to configure sFlow
■
for ports on modules that have not been inserted yet into the switch.
76.
76.
"Release K.13.04 Enhancements" on page
"Release K.13.04 Enhancements" on page
76.
76.
"Release K.13.04 Enhancements" on page
Software Fixes in Release K.11.12 - K.13.49
"Release K.13.04
"Release K.13.04 Enhancements"
"Release K.13.04 Enhancements" on
Release K.13.04
76.
76.
76.
184