Release K.13.06; Release K.13.07 - HP ProCurve 3500yl Release Notes

Software Fixes in Release K.11.12 - K.13.49

Release K.13.06

UDLD (PR_0000001433) — After the switch is rebooted, UDLD may continue to keep
■
switch ports in a blocked state.
■ VLAN Mirroring/Config (PR_0000001240) — The VLAN Mirroring configuration is
changed from its original value after updating from K.12.xx to K.13.03.
■ Bootup/Flash (PR_1000785118) — During the write-to-flash process, the OS file may
become truncated if the switch is interrupted (by crash or power outage, for example). This
fix minimizes that risk for ProCurve 3500yl, 6200yl, 5400zl Series Switches.
■ Bootup/Flash (PR_1000785113) — During the write-to-flash process, the configuration
file may become truncated if the switch is interrupted (by crash or power outage, for
example). This fix minimizes that risk for ProCurve 3500yl, 6200yl, 5400zl Series switches.
Release K.13.06
The following problems were resolved in release K.13.06 (not a public release).
■ Static Route/Config (PR_0000001471) — Rebooting a switch running K.13.03 may cause
the static route configuration to become corrupted.
OSPF (PR_1000385566) — When jumbo frames are enabled on a VLAN configured for
■
OSPF, the state stops at EXCHANGE and EXSTART.
UDLD (PR_0000001616 and PR_0000001638) — After the switch is rebooted, UDLD may
■
continue to keep ports in a blocked state, particularly if the port is in a static LACP trunk.
CLI (PR_0000001643) — The ip authorized-managers CLI command does not allow the
■
10.0.0.0 IP address to be used.

Release K.13.07

The following problems were resolved in release K.13.07 (not a public release).
■ Loopback Interface (PR_1000793862) — A ping or Telnet session to a loopback address
may fail intermittently. A traceroute to the loopback address completes successfully. This
may cause some protocol packets to fail to reach the loopback address.
■ Crash (PR_0000001689) — A switch running software version K.13.04 or higher may crash
during configuration of a trunk group from either the CLI or menu interface. Event log
messages may be similar to the following.
W 03/11/06 03:18:53 00374 chassis: Ports 25-48 Slave ROM Tombstone:
0x13000601
187