HP ProCurve 3500yl Release Notes page 34
Software version k.13.49
Hide thumbs
Also See for ProCurve 3500yl:
- Access security manual (778 pages) ,
- Specifications (16 pages) ,
- Features (6 pages)
Table of Contents
Advertisement
Known Issues
Minimum Software Versions
Web (PR_1000761014) — The Web interface truncates 16 character passwords to 15
■
characters. Workaround: configure 16 character passwords via the CLI.
■
ICMP (PR_1000764033) — ICMP TTL expired messages are being sent with a source
address of the interface the message leaves from rather than the interface that receives the
expired packet.
■
Auto-TFTP/Config (PR_0000001410) — Auto-TFTP configuration is lost during the
update from K.12.xx to K.13.03.
■
Web Authentication (PR_0000000968) — Web authentication to IAS over PEAP may
trigger a software exception crash with a message similar to the following.
Software exception at exception.c:501 -- in 'mWebAuth', task ID =
0x843c2b0 -> internal error
DHCP Snooping (PR_1000469934) — When DHCP Snooping is enabled and configured,
■
and a client sends a "DHCPINFORM" after receiving address information, the DHCP Server
response is not forwarded to the client by the switch.
■
CLI (PR_1000745509) — There are multiple issues with respect to the output from the
CLI command show ipv6 neighbor vlan <x>.
■
Module Selftest (PR_0000001273) — After reboot, ports 1-24 or ports 25-48 on the
ProCurve 3500yl or ports 1-24 on the 6200yl Switches may become unresponsive followed
by green and amber port LEDs remaining lit. Ports recover automatically. The log file will
show the following messages.
chassis: Ports 1-24: Slave ROM Tombstone: 0x13000601
chassis: Ports 1-24: Lost Communications detected - Heart Beat Lost(4A)
chassis: Ports 1-24 Downloading
chassis: Ports 1-24 Download Complete
chassis: Ports 1-24 Ready
■
ECMP (PR_1000798467) — A switch using OSPF ECMP may mis-route traffic for routes
with long prefixes (/31 or /32).
CLI (PR_1000782972) — The CLI command show system power provides incorrect output
■
for those regions that use a 220 volt standard.
CLI (PR_1000430534) — Output from the show port-access mac-based CLI command may
■
omit connected clients.
CLI (PR_1000776583) — The output for CLI command show access-list resources does not
■
accurately display the number of QoS/ACL masks available.
■
Config Transfer (PR_1000781015) — A config file transfer will fail with a "
configuration"
23
message, if the config file specifies MDIX-mode for a dual-personality port.
corrupted
Advertisement
Table of Contents
