HP ProCurve 3500yl Release Notes page 111

ProCurve(config)# show int custom 1-4 port name:4 type vlan intrusion speed
enabled mdi
Status and Counters - Custom Port Status
Port Name
---- ---------- ---------- ----- --------- ------- ------- --------
1 Acco
2 Huma
3 Deve
4 Lab1
Figure 20. Example of the Custom show interfaces Command
You can specify the column width by entering a colon after the column name, then indicating the
number of characters to display. In
of the name. All remaining characters are truncated.
Note
Each field has an fixed minimum width to be displayed. If you specify a field width smaller than the
minimum width, the information is displayed at the minimum width. For example, if the minimum
width for the Name field is 4 characters and you specify Name:2, the Name field displays 4 characters.
Parameters can be entered in any order. There is a limit of 80 characters per line; if you exceed this
limit an error displays.
Error Messages
Error
Requesting too many fields (total characters exceeds 80)
Field name is misspelled
Mistake in specifying the port list
The port list is not specified
Intrusion
Type VLAN Alert
100/1000T 1 No
100/1000T 1 No
100/1000T 1 No
100/1000T 1 No
Figure 20 the Name column only displays the first four characters
Release K.13.16 Enhancements
Speed Enabled MDI-mode
1000FDx Yes
1000FDx Yes
1000FDx Yes
1000FDx Yes
Error Message
Total length of selected data exceeds one line
Invalid input: <input>
Module not present for port or invalid port: <input>
Incomplete input: custom
Enhancements
Auto
Auto
Auto
Auto
100