Release K.11.44; Release K.11.46 - HP ProCurve 3500yl Release Notes

The following problems were resolved in release K.11.43 (not a general release)
■ Crash (PR_1000307842) — When deleting/removing CLI ACLs, IDM ACLs, management
VLAN, or virus throttle lockouts, switch crashes with error similar to:
"Delete virtual meter with nonzero rule RefCount".
Crash (PR_1000334982) — When Web authentication is used with open VLANs, a software
■
exception may occur, with the switch reporting something similar to this.
Software exception at wma_vlan_sm.c:289 -- in 'mWebAuth',
task ID = 0x81e408e0 -> ASSERT: failed
■ Enhancement (PR_1000358903) — 802.1X Controlled Directions enhancement. With this
change, Administrators can use "Wake-on-LAN" with computers that are connected to ports
configured for 802.1X authentication.
VRRP (PR_1000356388) — VRRP returns the physical MAC address instead of the virtual
■
MAC address when replying with proxy-ARP.

Release K.11.44

The following problems were resolved in release K.11.44 (not a general release)
Enhancement (PR_1000361504) — This enhancement allows STP to detect and block
■
network topology loops on a single port.

Release K.11.46

Version K.11.45 was never released.
The following problems were resolved in release K.11.46 (not a general release)
CLI (PR_1000345301) — The output from the "show config state" CLI command doesn't
■
always report changes made to the configuration.
CLI (PR_1000305584) — The output from the "show power" commands on the ProCurve
■
3500yl switches references slot letters when it should display port numbers.
■ Crash (PR_1000357083) — The switch management may run out of packet buffers and
crash with a message similar to:
Software exception at ngDmaTx.c:722 -- in 'tDevPollTx', task ID = 0x4305c504 ->
HW DMA DRIVER unable.
Hang (PR_1000359640) — The switch may hang on initialization and become
■
unresponsive.
Software Fixes in Release K.11.12 - K.13.49
Release K.11.44
154