Software Fixes in Release K.11.12 - K.13.49
Release K.12.08
Release K.12.08
Software never released.
Enhancement (PR_1000413764) — Increase the size of the sysLocation and sysContact
■
entries from 48 to 255 characters. For more information, see
Enhancements" on page
Release K.12.09
The following problem was resolved in release K.12.09 (Not a general release).
Crash (PR_1000385844) — With sFlow sampling enabled, the switch may crash with a
■
message similar to:
Software exception at ngDmaTx.c:729 -- in 'tDevPollTx',
task ID = 0x4305bba8 -> HW DMA DRIVER unable to transmit anymore
Release K.12.10
The following problems were resolved in release K.12.10.
ARP (PR_1000414347) — ARP table address learning is slow; once the switch has its ARP
■
table cleared, the clients will be unable to communicate for approximately 30 seconds.
Config (PR_1000416508) —- Cannot create alternate startup-config file. Although show
■
config files shows an available slot, the switch does not allow copying from an existing config
file to create a new config file in the vacant slot.
■
Crash (PR_1000421322) — Following execution of config-related CLI commands (such
as show running-config or show tech) or when PCM attempts to retrieve the configuration file
using TFTP from a switch having a large configuration file, the switch may crash with a
message similar to:
Software exception at exception.c:373 -- in 'tTftpDmn',
task ID = 0x11cfaa8 -> Memory system error at 0x1175550 - memPartFree
The following related crash message may also be addressed with this fix:
PPC Bus Error exception vector 0x300: Stack-frame=0x016778b0
HW Addr=0x667c4c88 IP=0x004dbc88 Task='eChassMgr'
Task ID=0x1677dd8 fp: 0x667c4c88 sp:0x01677970 lrecpgyp
Enhancement (PR_1000419653) — The show vlan command was enhanced to display
■
each port in the VLAN separately, display the friendly port name (if configured), and display
the VLAN mode (tagged/untagged/forbidden) for each port. For more information, see
"Release K.12.10 Enhancements" on page
165
57.
58.
"Release K.12.08
Need help?
Do you have a question about the ProCurve 3500yl and is the answer not in the manual?