Release K.13.03 - HP ProCurve 3500yl Release Notes

CLI (PR_1000455370) — Commands that display portmaps may yield corrupted
■
output. For example, a single port may be displayed as a port range.
■ RIP (PR_1000751858) — Some static routes may not be correctly distributed by RIPv1 or
RIPv2.
■ PIM (PR_1000714322) — A new multicast stream may not get forwarded by the switch.
■ Crash (PR_1000759046) — Using the "\" character with or without other character
combinations may cause the switch to crash with a message similar to the following. There
may also be different crash messages resulting from the same problem.
Software exception at parser.c:2653 — in 'mSess1', task ID =
0x898e6a0-> ASSERT:
PIM (PR_1000749627) — A switch with PIM-SM may send a prune to the RP when none
■
is required.
■ Web Management (PR_1000472572) — The Web Management Interface does not
properly allow configuration of port monitoring/mirroring.
Addendum to Release K.13.02:
ACL (PR_1000714376/1000760152) — Attempts to apply an access group to a range of
■
ports will fail after the initial configuration unless a write mem and reload are done in
between configuration statements.

Release K.13.03

The following problems were resolved in release K.13.03.
Enhancement (PR_1000400991) — The 802.1X Controlled Directions feature now
■
functions independently of the STP configuration. For more information, see
K.13.03 Enhancements" on page
IPv6 (PR_1000768670) — When virus throttling is configured on a port that belongs to an
■
IPv6 enabled VLAN, some IPv6 all nodes (ff02::1) multicast traffic may be dropped.
Mirroring (PR_1000768655) — After a mirror ACL has been modified, some ACL
■
commands that follow may result in an unresponsive CLI session.
■ IDM ACL (PR_1000768727) — An IDM ACL that uses the syntax, destination ip "any"
will result in a parsing error, the ACL will not be applied, and the client authentication will
fail. Workaround: Instead of the term "any," use "0.0.0.0/0."
■ VRRP PDT (PR_1000756475) — If the VRRP preemptive delay timer (PDT) is configured,
the virtual router mode (Owner or Backup) cannot be changed unless the PDT configuration
is removed.
failed
75.
Software Fixes in Release K.11.12 - K.13.49
"Release
Release K.13.03
182