Release K.12.18; Release K.12.19 - HP ProCurve 3500yl Release Notes

Software Fixes in Release K.11.12 - K.13.49

Release K.12.18

Release K.12.18
The following problems were resolved in release K.12.18.
CLI (PR_1000419379) — The "interface" command does not exist in the VLAN context,
■
resulting in an inability to shift to the interface configuration context directly from the VLAN
context.
Hang (PR_1000434809) — The switch may hang, causing all the port LEDs to remain lit,
■
and stop transmitting traffic.
■ Enhancement (PR_1000428213) — This software enhancement adds the ability to
configure a secondary authentication method to be used when the RADIUS server is
unavailable for the primary port access method.
■ Crash (PR_1000436274) — Typing a question mark ("?") at the "multi-line" input prompt
(">") may cause the switch to crash. The crash occurs when the switch is trying to print the
error message that states:
Expansion help not available on multi-line input.
CLI (PR_1000433948) — When command authorization is in use, the "show tech"
■
command fails at the "show tech buffer" component, even when the permission list indicates
that it should be allowed.
Enhancement (PR_1000415155) — The ARP age timer was enhanced from the previous
■
limit of 240 minutes to allow for configuration of values up to 1440 minutes (24 hours) or
"infinite" (99,999,999 seconds or 3.2 years).
Enhancement (PR_1000438015) — The banner message of the day (MOTD) size has been
■
increased to support up to 3070 characters.

Release K.12.19

The following problems were resolved in release K.12.19.
■ ACL (PR_1000432563) — ACLs with the "permit" parameter on L4 ports and using
operators 'gt'/'lt'/'range' do not function as expected. The ACL does not drop traffic with
non-permitted L4 ports. Instead, all traffic with L4 ports is forwarded.
■ CLI (PR_1000438486) — When using the "port-access mac-based" CLI command, the client
MAC address is sent in lower case and as the username to the RADIUS server. This fix adds
an option so that the MAC address is in uppercase when sent to the RADIUS server. This fix
adds additional parameters to the CLI command to support this: "aaa port-access mac-based
addr-format."
169