HP ProCurve 3500yl Release Notes page 93

Software version k.13.49
Hide thumbs Also See for ProCurve 3500yl:
Table of Contents

Advertisement

The VRs operating VLAN can't be configured as a tracking VLAN for that VR.
Ports that are part of a trunk can't be tracked.
A port that is tracked can't be included in a trunk.
Trunks that are tracked can't be removed; you are not able to remove the last port from
the trunk.
LACP (active or passive) cannot be enabled on a port that is being tracked.
If a VLAN is removed or a port becomes unavailable, the configuration is retained and
they are tracked when they become available again.
After the Owner VR relinquishes control of its IP address, that IP address becomes
unavailable to all other applications and routing protocols such as RIP and OSPF.
To avoid operational issues, it is recommended that VRRP is not run on the same
interface/VLAN with other routing protocols, such as RIP and OSPF.
Error Messages
Track Interface
Message
VR must be defined as "backup" first
Invalid input: <out of range value>
VR operation must be "down" prior to modifying VR's
parameters
Can't track a port that is part of a trunk
Tracking is disabled on owner
Cannot remove trunk being tracked by VRRP
Cannot enable LACP on a VRRP tracked port
Too many entities to track
Cannot track trunk/LACP member
VRRP tracked port is not allowed in trunk
VRRP tracked port is not allowed in LACP
Operation is not permitted on VR when it is configured as
owner or is uninitialized.
Description
You have to declare a VR as Backup before assigning a
track interface to it.
You have to assign a valid port or trunk to the VR instance.
You cannot change the track interface when the VR is
active. Use the no enable command to disable the VR.
You can't configure tracking on a port that is a member of
a trunk.
You can't configure a track interface on an Owner VR.
You can't remove a trunk that is being tracked by a VR
You can't enable LACP on a port that is being tracked by a
VR.
You have selected too many entities to be tracked by the
VR.
You can't track the specified trunk or LACP member.
You can't add this tracked port to a trunk.
You can't use LACP with the tracked port.
The VR must be a Backup and initialized in order to execute
the operation.
Enhancements
Release K.13.04 Enhancements
82

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve 8212zlProcurve 5400zl6200yl

Table of Contents