Release K.13.04 Enhancements; Clear Module Configuration - HP ProCurve 3500yl Release Notes

Release K.13.04 Enhancements

Release K.13.04 includes the following enhancements.
Enhancement (PR_ 0000000081) — The CLI clear module command allows you to remove
■
module configuration information from the configuration file.

Clear Module Configuration

Overview
Because of the hot-swap capabilities of the modules, when a module is removed from the chassis of
a ProCurve series 5400 switch, the module configuration remains in the configuration file. This
enhancement allows you to remove the module configuration information from the configuration file.
Syntax: [no] module <slot>
Allows removal of the module configuration in the configuration file after the
module has been removed. Enter an integer between 1 and 12 for <slot>.
For example:
ProCurve(config)# no module 3
Note
This does not change how hot-swap works.
Operating Notes
The following restrictions apply:
The slot being cleared must be empty
■
■ There was no module present in the slot since the last boot
■ If there was a module present after the switch was booted, the switch will have to be rebooted
before any module (new or same) can be used in the slot.
This does not clear the configuration of a module still in use by the switch.
■
Enhancements
Release K.13.04 Enhancements
76