Table of Contents
Advertisement
Chapter 6. Using system-level utilities
The following utilities are provided with each appliance engine.
Note: Using these utilities for each appliance engine requires the attachment of a
v Configuration/Setup Utility
v SCSISelect Utility
Using the Configuration/Setup Utility program
This section provides the instructions needed to start the Configuration/Setup Utility
program and descriptions of the menu choices available.
Starting the Configuration/Setup Utility program
To start the Configuration/Setup Utility program:
1. Power-on the appliance engine and watch the monitor screen.
2. When the message Press F1 for Configuration/Setup appears, press F1.
3. Follow the instructions that appear on the screen.
Choices available from the Configuration/Setup main menu
From the Configuration/Setup Utility main menu, you can select settings that you
want to change. The Configuration/Setup Utility main menu is similar to the
following:
© Copyright IBM Corp. 2001
monitor, keyboard, and mouse.
The Configuration/Setup Utility program is part of the basic input/output system
(BIOS) that comes with each appliance engine. You can use this program to
configure serial and parallel port assignments, change interrupt request (IRQ)
settings, change the drive startup sequence, set the date and time, and set
passwords. See "Using the Configuration/Setup Utility program" for more
information.
With the built-in SCSISelect Utility program, you can configure the devices
attached to the integrated SCSI controller. See "Using the SCSISelect utility
program" on page 117 for more information.
Note: If you have set both levels of passwords (user and administrator), you
must enter the administrator password to access the full
Configuration/Setup menu.
111
Advertisement
Table of Contents
Troubleshooting
