Removing A Hard Disk Drive; Installing The Ds4100 Into A Rack Cabinet; Removing A Drive Cru - IBM TotalStorage DS4100 Installation, User's, And Maintenance Manual

Removing a hard disk drive

Complete the following steps to remove a hot-swap hard disk drive:
Note: The hard disk drive comes installed in a drive tray. Do not attempt to detach
1. Use Table 19 on page 119 to record the location and identify your DS4000
2. Release the latch on the drive CRU by pinching together the blue line on the
3. Pull the tray handle out so that it is in the open position to release the drive
Tray handle
Figure 16. Removing a drive CRU
4. Place the removed drive CRUs horizontally on a level surface, with the printed
5. Repeat step 1 through step 4 for additional drive CRUs.
Continue with "Installing the DS4100 into a rack cabinet."

Installing the DS4100 into a rack cabinet

Complete the following steps to install the DS4100 in a rack cabinet.
1. Place the DS4100 in the rack cabinet.
28
IBM TotalStorage DS4100 Storage Server: Installation, User's, and Maintenance Guide
the hard disk drive from the drive tray.
SATA hard disk drives. You must record this information to be able to replace
the hard disk drives in their original order before they were removed.
tray latch and the finger hole on the tray handle.
CRU. Pull the drive out of the bay, as shown in Figure 16.
circuit boards facing down.
Attention: Do not stack drive CRUs on top of one another. Protect the drive
CRUs from vibrations or sudden shocks.
Note: If you have removed the CRUs from the DS4100, you should be able to
lift the unit into the cabinet with the help of one other person. If you have
not removed the CRUs before the installation, you should have at least
two other people available to help you lift the unit into the rack cabinet.
a. Move the DS4100 to the front of the rack-mount cabinet.
b. With help from another person, place the back of the storage server on the
support rails. Slide the unit into the rack cabinet, as shown in Figure 17 on
page 29.