Removable Media Devices; Installing A 5.25-Inch Device - NEC Express5800 User Manual

Removable Media Devices

A variety of IDE removable media devices can be installed in peripheral bays B
and C. An IDE CD-ROM is always mounted in bay A. A 3.5-inch diskette drive
is always mounted in bay D. See Figure 4-32. Contact your sales representative
or dealer for a list of approved IDE devices.
Figure 4-32. Removable Media Device Locations

Installing a 5.25-Inch Device

CD-ROM devices contain a laser system and are classified
as CLASS 1 LASER PRODUCTS. To use these devices,
thoroughly read the documentation provided by the CD-
ROM manufacturer, and keep the documentation for future
reference. In case of any trouble with a CD-ROM, please
contact your nearest service representative. To prevent
direct exposure to the laser beam, do not try to open the
enclosure. Use of controls or adjustments or performance of
procedures other than those specified in the CD-ROM
manufacturer's documentation may result in hazardous
radiation exposure
1. Power off the system and remove the side panels as described earlier in this
chapter.
2. Remove the front panel, EMI shield, and filler panel covering the bay into
which you are installing a peripheral device as described earlier in this
chapter.
Observe static precautions. Use an antistatic wrist strap.
3. Remove the device from its protective wrapper and place it on an antistatic
surface. Record the drive model and serial number in the equipment log.
BAY A
BAY B
BAY C
BAY D
! CAUTION
! CAUTION
Upgrading Your System 4-29