Advertisement
turn the hardware knob to go through the complete range of values. The
lowest value is 30° and the highest is 3600°, meaning that you have to
make ten full cycles to go through all values.
In the P
menu you have the choice between:
edal
►
None, for no Pedal input
►
Pedal 1 or Pedal 2 for controlling the respective Controller via one of
the two Pedals that may be connected to your KORE 2 Controller.
For the buttons of your KORE 2 Controller the C
parameters more than for the knobs.
The B
menu controls the mode of the button:
eHaVior
►
Toggle means the button switches state with every button hit.
►
Trigger only sends one message if you hit the button. Depending on
the a
o
parameter, this can be "down" or "up". Use this to get
Ction
n
buttons that can only switch on/off other buttons.
►
Gate leads to an on state while the button is being held down and
switches to off when it is released.
The a
setting decides if the action of the button is happening on
Ction on
the down or the up state of the button. This only works with the Toggle
and Trigger behaviors.
In the F
menu you have the choice between:
ootSwitCH
►
None, for no Footswitch input
t
has a few
ontrol
aB
KORE 2 – 93
Advertisement
