Native Instruments O Kore 2 Operation Manual page 224

adapted to the needs of the particular Ensemble. This should be done in
Reaktor stand-alone, for convenience. stand-alone, for convenience.
As a first step, the local list(s) of the instrument(s) have to be prepared.
Execute the Sort and Compress IDs command from the instrument's prop- Sort and Compress IDs command from the instrument's prop- command from the instrument's prop-
erties. Then set the MAX ID value to the number of MAX ID IN USE value MAX ID value to the number of MAX ID IN USE value value to the number of MAX ID IN USE value
to make sure that no parameter is masked from the global list. After
doing this for each instrument within the Ensemble use the Instrument Instrument
Up and Instrument Down commands to position the instruments within and Instrument Down commands to position the instruments within Instrument Down commands to position the instruments within commands to position the instruments within
the global list. Perhaps it might be useful to use the Ensemble's signal
flow as a template for the instrument's order within the global parameter
list. Finally check whether the most important parameters use GLOBAL GLOBAL
ID values below 1000, as this is the maximum number of parameters values below 1000, as this is the maximum number of parameters
supported by most plug-in protocols. Here, once more it is important to
remember that changing the IDs causes incompatibility to prior automa-
tion assignments within a host. The changed Ensemble should be saved
with a new filename. new filename. .
KORE 2 – 22