Advertisement
Label
Sets the balance between the dry, unprocessed signal and the "wet" (filtered)
Mix Dry-Wet
one.
Changes the cutoff frequency of the internal allpass filters of the Phaser, lead-
Center
ing to a shift in phasing frequencies. This interacts with the modulation, as it is
added to this value (have a look at the Modulation Meter).
Modulation Sync
Synchronizes the frequency of the LFO to KORE 2's time base.
Modulation Rate
Adjusts the delay time modulation speed, i.e., the internal LFO's frequency.
Modulation Depth
Sets the amount of modulation as a percentage of the delay time
Sets the phase offset of the LFO modulating the right or left channel delay
Modulation LR Phase
times, respectively. At the maximum setting the
Feeds the output of the chain of allpass filters back into its input leading to a
Color Feedback
shift in phasing frequencies.
This influences the way the phase rotation changes with higher frequencies lead-
Color Bandwidth
ing to a different set of peaks and dips in the spectrum. Higher settings spread
the frequencies at which the peaks and dips sit.
Sets the cutoff frequency of a lowpass filter in the chain of allpass filters. Use
Color Low Cut
this to block out unwanted low frequency resonances.
Invert Mix
If on, the processed signal is phase-inverted before being mixed with the input.
Function
Range
Unit
0..100
%
0..100
%
On/Off
0..10
Hz
0..100
%
De-
0..180
grees
-100..+100
%
0..100
%
25..800
Hz
On/Off
KORE 2 – 175
Advertisement
