Advertisement
Keyboard shortcut
Depth
Controls the intensity of modulation applied to the delay time.
Shows the delay time resulting from the setting of [Center] and the added
Modulation Meter
modulation signal.
Phase L/R
Changes the phase of the left and right signal paths, respectively.
Sets the amount of Feedback, i.e. how much of the output signal is fed back
into the input. With a negative Feedback the output of the internal delay line
Feedback
is inverted before it is fed back into the input. This leads to a different set of
peaks and drops in the spectrum.
Low Cut
Sets the cutoff frequencies of the low pass/high pass filters modifying the
High Cut
feedback signal. Frequencies above/below the set cutoff are attenuated.
Function
Range
Unit
0..100
%
-180..+180
deg
-100..100
%
25..1000/
Hz
10..20000
KORE 2 – 151
Advertisement
