Native Instruments O Kore 2 Operation Manual page 199

upper section of the markers to drag them into any position. Use this to
set up 32 steps worth of content that can be arranged on the fly via the
markers.
The small dice to the left of the keyboard is the P
it to generate a random pattern of steps on the grid.
Below the S g you can find an area with three additional parameters
teP rid
per step: V , o
eloCity CtaVe
far left of the interface.
The values are defined by clicking on the vertical columns under the Step
Grid and dragging them up or down. By clicking on the three tabs you can
switch between the three parameters:
► V controls the MIDI velocity of the sequencer steps. It ranges
eloCity
from 0 to 127. You can randomize the velocity for all steps by clicking
on the Velocity Randomizer (the small dice symbol).
►
o transposes the octave of the sequencer up or down by one or
CtaVe
two octaves. Again, this can be randomized. The octave value is always
relative to the P
itCH
and t . These are accessed via three tabs to the
ie
o setting (see below).
CtaVe
r r . Use
iano oll andoMizer
%
Note that you can assign
the Loop Marker position
to knobs on your Kore Controller.
KORE 2 – 199