Advertisement
The t
button defines if the incoming note messages that feed the
Hru
Arpeggiator are transmitted downstream to the next C
not. If inactive, the Arpeggio start is dependent on the Clocksync setting.
If active, the notes you played on the keyboard will also immediately
trigger sounds in the instrument (if the Arpeggiator goes directly into an
instrument).
In the t
section you will find the r
iMe
step width of the pattern. It ranges from whole notes (1) to 6th notes (6)
and is relative to the global clock or host clock, respectively. The
and
buttons change the grid of the played notes to dotted or triplets.
dotted
These two parameters can only work alternatively, not both at the same
time. They lead to the following changes in grid length:
►
A d
note adds the half of the note value (as defined by Rate). If
otted
you have a rate of 2 (for half notes) the dotted option leads to a grid
spacing of three beats length.
►
t
(also called trioles) lead to notes that are two thirds as long as
riPletS
the grid width defined by Rate. If Rate is set to fourth and the triplet
button is active, three notes correspond to a half note.
Hannel
menu. Here you can choose the
ate
i
or
nSert
triPletS
KORE 2 – 192
Advertisement
