Advertisement
Label
Controls the balance between the dry, unprocessed signal (at the left) and the
Mix
wet, processed signal (at the right).
Delay Time
Sets the effect unit's initial delay time. The internal LFO modulates this value.
Controls the delay time balance as a percentage of the initial delay time. Nega-
Delay Time LR Offset
tive values decrease the left delay time while the right delay increases by the
same amount. Positive values create the opposite effect.
Modulation Sync
Synchronizes the frequency of the LFO to KORE 2's timebase.
Modulation Rate
Adjusts the delay time modulation speed, i.e., the internal LFO's frequency.
Modulation Depth
Sets the amount of modulation as a percentage of the delay time.
Sets the phase offset of the LFO modulating the right or left channel delay
Modulation LR Phase
times, respectively. At the maximum setting the LFO signal is 180° out of
phase.
Feedback Amount
Sets the level of the delayed signal that feeds back to the effects input.
Sets the level of the delayed signal that feeds back into the opposite channel
Cross Feedback
(i.e., the left channel's output into the right channel's input and vice versa), as a
percentage of the main feedback amount.
Inverse Feedback
Turns the feedback signal phase inversion on or off.
Sets the cutoff frequency of the low pass/high pass filters that modify the de-
Filter Low/High Cut
layed signal. Frequencies below/above are attenuated with a slope of 12 dB per
octave.
Function
Range
Unit
0..100
%
0..1500
ms
-33..+33
%
On/Off
0..10
Hz
0..100
%
0..180
De-
grees
0..100
%
0..100
%
On/Off
10..5000/
Hz
100..25000
KORE 2 – 166
Advertisement
